ADU Construction in Temple City
Temple City ADUs planned from the curb back: the delivery route to the yard, how the older house is shielded and how the new unit matches it.
Before a Temple City ADU can go up, every delivery has to find a way from the curb to the back of the lot. On the first visit we walk that route with a tape: the driveway width, the narrowest pinch beside the house, low eaves, gas and electric meters on the side wall, and gates that need to come off. That path sets how materials are staged and how the older house is shielded while work goes past it.
Delivery when the route is narrow
A driveway that runs to the back makes deliveries simple. Where it does not, concrete arrives through a pump hose laid along the fence, and lumber comes precut in bundles light enough to carry. Bulky pieces such as a shower pan or water heater are brought in before the framing closes them out. A temporary path of plywood protects lawn and paving, and meters on the side wall get a guard frame so nothing clips them. Keeping that path open also gives inspectors and trades a clear way back.
Fitting the unit to the house and the city's rules
Temple City checks the unit for compliance with the state's ADU law and with the city's height and setback standards. Inside those limits, the design takes its cues from the main house: the same roof pitch, a matching overhang, siding laid at the same exposure and windows of similar proportion. The unit's ridge stays below the house's so the original building still reads first from the street. Utility trenches are routed to miss the porch footing and any original walkway, so the older house loses nothing to the new work.
About our ADU Construction serviceEverything we do in Temple City
ADU Construction in Temple City: common questions
Each line is located and measured against the new demand. We film the sewer lateral, read the panel's rating, total the unit's appliance loads against the panel and note the water meter size. Whatever the older house cannot share, such as a fuse panel or galvanized supply, goes into the scope as an upgrade.
Frequently, and it sidesteps the access problem since the building is already in place. We still test the slab, look for footings, and check the framing and roof for sag or rot. A sound garage gets insulation, windows, finished walls and utilities. A weak one is usually better replaced by a new unit on its footprint.
We measure the house before sketching. Roof pitch and eave depth carry the most resemblance, followed by siding exposure and the shape of the windows. Casing is milled to the original profile when stock boards look too thin. Paint is mixed to the house colors, so the unit and the house share a palette.
ADU Construction in other cities
Other work we do in Temple City
Talk to us about your house in Temple City
Send the details and we will set up a walk-through and a written scope.