Walnut Windows & Doors in the Right Order

In an older Walnut house the finished floor height is settled before a new exterior door is ordered, so its threshold, swing and bottom seal fit the floor.

Tell us about the house

We reply with a time to walk the house, then a written scope you can read line by line. How we use your details.

To send, add your first name and a phone number or an email.

The finished floor gets settled before the door. When an older Walnut house is getting new flooring along with new exterior doors, the floor height at each doorway has to be fixed before a door is measured, because the threshold, the swing over rugs and the seal at the bottom all depend on it. A door ordered to the old floor can end up dragging on new tile or leaving a gap over thinner flooring.

Marking the floor line

We confirm the flooring material and its full build-up, including any underlayment or mortar bed, and mark the finished height on the jamb at each doorway. Tile on a mortar bed can sit well above the old wood, and a floating floor adds its own height over a pad. With that line marked, the frame is set so the door bottom clears the finished floor and any rug, and the threshold meets the floor without a trip edge. Where the old floor stays, its height at the doorway is measured directly and the same steps follow.

Windows inside a larger job

Windows keep their own order when other work is going on. Any framing change around an opening is made and inspected first. The opening is then flashed and the unit set, and only after that does plaster or drywall patching begin, so the patch meets a fixed frame. Interior casing is the last trim to go up before paint, which keeps it clear of the dust from earlier steps. Exterior paint waits until the sealant has cured. Kept in that order, nothing finished has to be pulled off again to fix something underneath it.

About our Windows & Doors serviceEverything we do in Walnut

Windows & Doors in Walnut: common questions

Talk to us about your house in Walnut

Send the details and we will set up a walk-through and a written scope.