Fire Rebuild & Reconstruction in Burbank
Fire rebuild and reconstruction in Burbank, CA: old wiring and pipe behind standing walls are tested first, then the rebuild is planned and priced.
Behind a plaster wall the fire never touched, an older Burbank house can still hold cloth-covered wiring or galvanized supply pipe. Finding either one changes the scope, because heat and smoke leave old insulation brittle and old pipe weakened. A small test opening goes in early, so the discovery is priced and drawn before framing starts and the new work ties into circuits that are sound.
Wiring and pipe behind standing walls
Heat travels further than flame. In a wall that still stands, a switch plate comes off and two small inspection holes go in, one high and one low in the cavity. Cloth-covered conductors, circuits with no ground wire and galvanized supply lines all show themselves that way. Smoke and heat can crack old insulation even where the paint looks fine. A circuit that fails the check is replaced to current code, then the wall is closed with plaster or drywall that matches the room.
What one find does to the plan
A bad circuit or a corroded pipe seldom stays in one room, because the same feed usually serves the next room too. One discovery can move the electrician and the plumber ahead of the drywall stage across a whole floor. Each location is marked on the plan set before the permit is filed, so the inspector sees the real extent of the work. Casings, doors and baseboards that come off to reach a cavity are labeled and set back once the new work passes inspection.
About our Fire Rebuild & Reconstruction serviceEverything we do in Burbank
Fire Rebuild & Reconstruction in Burbank: common questions
Some of it. An engineer tests the slab, the chimney base and the framing that still stands. Wiring and plumbing inside walls need their own check, since heat can harm them without a visible mark. Doubtful items come out and are listed in the written scope.
From the street, usually. Old photos, permit drawings and whatever detail survives set the roofline, window pattern and trim. Behind the surfaces, current code governs, so framing, wiring and insulation change, and engineered details replace the old guesswork.
Permits come in sequence: demolition for what is torn down, followed by a building permit for the new house, with electrical and plumbing covered. The city building department reviews the drawings and checks the work. Your designer and we assemble the set, and we file it.
Fire Rebuild & Reconstruction in other cities
Talk to us about your house in Burbank
Send the details and we will set up a walk-through and a written scope.