Bathroom Remodeling in Studio City, CA
Bathroom remodeling for older Studio City houses: water pressure read first, then new supply lines, a working fan duct and the original details kept.
Water pressure is the reading taken before a Studio City bathroom gets a price. A gauge threads onto a hose bib near the room, and the tub, sink and toilet are run together to see how far the flow falls. A big drop points to scale inside old galvanized pipe, which puts new supply lines in the scope. A static reading above 80 psi adds a regulator at the main, since the plumbing code caps pressure at the fixtures.
Under the sink and above the ceiling
With the gauge off, a flashlight goes into the vanity and behind the tub access panel if the house has one. Corroded shutoffs, a slow drip at a slip joint or dark wood around the tub trap all hint at what the floor is hiding. The fan is switched on and a tissue held to its grille to see whether it pulls. If the attic can be reached, the duct is traced to learn whether it ends at an exterior cap or dumps moist air onto the roof framing.
What the readings change
Each reading becomes a line in the written scope. New PEX or copper supply runs from the main branch to every fixture, and a regulator is listed when pressure called for it. A fan with a broken or missing duct gets new metal duct to a damper cap outside. Studio City lies within the City of Los Angeles, so LADBS permits the job and its inspector sees the rough plumbing before walls close. Original pieces worth keeping, such as a recessed cabinet or a wood window, are named in the scope as well.
About our Bathroom Remodeling serviceEverything we do in Studio City
Bathroom Remodeling in Studio City: common questions
Galvanized supply pipe may turn up, with rust inside that chokes the flow. A lead bend under the toilet may join a cast iron drain. The tile may sit on a thick mortar bed over wire mesh. Where water got past the grout around the tub, the subfloor can be spongy, and that wood is replaced ahead of new tile.
Yes, when it is cast iron and the alcove suits the new layout. It stays covered while the walls around it are redone, or it is lifted out if the floor beneath needs repair. A new waste and overflow set and a new valve are fitted, and a refinisher can renew the surface without removing the tub.
Waterproofing begins at the floor, which is built up with a fall toward the drain. A sheet or liquid membrane covers that floor and the walls and laps into the drain flange. The shower is then filled with water and watched so any leak shows before tile. The membrane keeps the water in, and the tile protects the membrane.
Bathroom Remodeling in other cities
Other work we do in Studio City
Talk to us about your house in Studio City
Send the details and we will set up a walk-through and a written scope.